Changing frequency setting, Operation lights – Casablanca Fan Company Holliston C31UxxZ User Manual

Page 29

Advertising

ChanGinG FRequenCY SettinG

NOTE: All fans leave the factory set to

“1111”

You will only have to change the dip switch settings in the remote if you

are using more than one fan in the same area and want to control them

separately.

diP SWitCheS

Set to ‘1111’

(Factory Setting)

diP SWitCheS

Set to ‘1001’

note: do Not set dip switch setting in the remote

to ‘0000’, this may cause frequency interference from

other Casablanca Products.

Step 1. turn power oFF at the circuit breaker or fuse box and at the toggle

switch, for the fan you want to change.

Step 2. Remove the screws and switch plate from the existing switch box.

Step 3. Remove the screws holding the switch in the switch box.

Step 4. Pull the existing w-84 switch from the switch box to expose the dip

switches located on the side of the control as shown in Figure #1.

Step 5. Change the dip switch settings, assuring that they are different from

the previously installed Inteli-touch

3 fan.

Step 6. Mount the w-84 wall Control unit back into the wall electrical box.

Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the

power off for the fan whose frequency you are changing.

Step 8. within 20 seconds of restoring power to the ceiling fan and the w-84

wall Control press and hold both the “FAN” and “REVERSE” buttons as

shown in Figure #2. For 3 seconds, you will hear one tone from the Piezo

Buzzer indicating the command has been accepted.

diP

SWitCheS

(Figure 1)

(Figure 2)

NotE: Light Operation -

the light varies from “bright”

to “dim” over approximately

8 seconds. this sequence

will reverse the light when

it reaches the brightest

or dimmest level if you

continue to hold the lIGHt

button. Release the button

when the desired level is

reached.

oPeRation LiGhtS

to dim just the up light:

1. Make sure you have just the downlight on.

2. turn the light off, then press and hold the

button. After one

second, the up light will come on at their lowest setting and gradually

become brighter or dimmest level if you continue holding the

but-

ton.

3. Release the

button when the desired brightness is reached.

to dim just the down light:

1. Make sure you have both lights on.