Canon B115 - Manual (Page 101)

1-6
Connecting the AC power cord ________________
Plug the fax into a 200-240 volt AC 50/60 Hz outlet.
Setting the language and country ______________
When you plug in the fax for the first time, you need to select the correct language for the LCD display and
reports, and the country* of use. See pp. 2-2, 2-3 for the buttons on the operation panel.
1 Plug the power cord connector into the
rear of the fax. 2 Plug the other end of the power cord into
a properly grounded AC power outlet.
Note
There is no power switch on the fax. The power is on as long as the fax is plugged in.
1
Press [Start/Copy].
2
Use [ 3 ] or [ 4 ] to select the preferred language for
the LCD display and reports.
D
Press [Start/Copy].
Wait a second for COUNTRY SELECT* to appear.
D
Press [Start/Copy].
3
Use [ 3 ] or [ 4 ] to select the country where you are
using the fax*.
D
Press [Start/Copy].
Registration ends and the fax enters standby mode.
EUROPE
* This setting is only available for some countries.