Canon B115 - Manual (Page 58)

7-15
7
US
ING
T
H
E
B
U
IL
T-I
N
A
N
S
W
ER
ING
MA
CHI
NE
(TA
M
MODE) (FA
X
-B
140 o
n
ly
)
When a forwarded call is received
When FWD SETTINGS is set to ON, telephone messages recorded when the fax is set to TAM MODE will
be automatically forwarded to a registered forwarding number.
1
A call is received at the forwarding number.
2
When you answer the phone you will hear your
forwarding message.
3
Press [#] while the forwarding message is playing.
If you have not set a forwarding message, press [#] when
you hear the tone.
4
Enter your password when you hear the beeps
• When PIN ENTRY is set to OFF (see p. 7-14), step 4 is not
required.
• If you enter an invalid password, you will hear an error tone.
If you enter two invalid passwords consecutively, the call
will be disconnected.
5
Any new telephone messages will be played.
6
When playback ends, it will be possible to use the
remote control features.
or the remote control features, see pp. 7-9 to 7-11.
7
Hang up the handset when you have finished.
Note
• When forwarding is not possible:
You can set the fax to redial the forwarding number a certain number of times at specified intervals
when forwarding is not possible, such as at times when the forwarding number is busy or the phone
is unattended. If forwarding is still not possible after the fax redials the forwarding number the
specified number of times, the forwarding setting will be temporarily cancelled. However, the fax
will dial the forwarding number again when any new telephone messages are received.
• You should enter a remote command within 20 seconds of entering your password. If more than
20 seconds elapse after you enter your password and you do not enter a remote command, the call
will be disconnected.