Canon Multimedia Projector LV-8235 UST - Manual (Page 60)

60
Setting
Closed Caption is a function that displays the audio portion
of a TV program as text on the screen. If the input signal
contains Closed captions, you can turn on the feature and
switch the channels. Press the Point  buttons to select
Off, CC1, CC2, CC3 or CC4.
If the Closed caption is not clear, you can change the text
from Color to White.
Closed caption
Note:
The Closed caption is available only under the situation
below.
• The input signal is
NTSC of composite video or S-video.
• The item of Closed caption is displayed in gray while it
is not available.
• The Closed caption is unavailable when On-Screen
Menu or P-Timer is displayed.
Press the Point  buttons to
select Off, CC1, CC2, CC3 or CC4,
and then Press OK button.
Remote control
This projector provides two different remote control codes:
the factory-set initial code ( Code 1) and the secondary code
( Code 2). This switching function prevents remote controller
interference when operating several projectors or video
equipment at the same time.
When operating the projector in Code 2, both the projector
and the remote controller must be switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting Menu.
To change the code for the remote controller:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote controller operates properly.
Note:
• When different codes are set on the projector and on
the remote controller, any operation cannot be made. In
that case, switch the code on the remote controller to fit
the code on the projector.
• If the batteries are removed from the remote controller
for a long period of time, the remote control code will be
reset.
This function allows you to change brightness of the screen.
Normal ..... Normal brightness.
Eco .......... Lower brightness reduces the lamp power
consumption and extends the lamp life.
Closed caption
Lamp mode
Remote control