Canon Multimedia Projector LV-8235 UST - Manual (Page 33)

33
3D
Choose COMPUTER2 (ANALOG PC) by press the
COMPUTER 2 button on the remote controller.
Note:
When the Auto input function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.53).
COMPUTER 2 button
Remote Controller
1
2
Press the MENU button to display the On-Screen
Menu. Press the Point  buttons, move the highlight
to Input and then press the Point  or the OK button.
Use the Point  buttons to select COMPUTER 2 and
then press the OK button.
Input Menu
COMPUTER 2
(ANALOG PC) *
3
When COMPUTER 2 is selected, ANALOG PC input
source will be selected directly.
Input Source Selection (COMPUTER 2: ANALOG PC)
Direct Operation
Menu Operation
Computer Input
Note:
* COMPUTER 2 can not be selected when
using the COMPUTER IN 2/ MONITOR
OUT terminal as MONITOR OUT.
"Monitor out" message will appear on the
screen when COMPUTER 2 button is
pressed while using the COMPUTER IN
2/ MONITOR OUT terminal as MONITOR
OUT.