Canon DR-6030C - Manual (Page 89)

Software Setup 83
Chapter 3
Feeding Option
Here you can select the feeding method for document scanning.
[Standard Feeding]
This feeding method is good for scanning small batches of documents that are
loaded one batch at a time: scanning stops when the loaded documents have
been scanned.
[Panel Feeding]
This feeding method is good for scanning batches of documents of different
sizes: after loading the documents, press the Job button (assigned as a Start
button on the scanner) to start scanning, and press the assigned Stop button to
stop scanning.
☞ When scanning documents with different-size pages, after loading the
documents, you can adjust the document guide position.
[Automatic Feeding]
This feeding method is good for scanning batches of same-size documents:
scanning starts when the scanner detects loaded documents, and stops when
you press the Stop button.
☞ When [Automatic Feeding] is selected, the [Setting] button is enabled to
allow setting the delay time from when a loaded document is detected until
scanning starts. (See “Scanning Multiple Documents,” on p. 94.)
☞ When the feed selection lever on the scanner is in the down position ( ),
the feeding option is set to bypass mode and cannot be changed. (See “How
to Feed with the Bypass Mode,” on p. 30.)
Batch Separation (ISIS driver only)
Items available for selection depend on the Feeding Option setting: select
batch separation timing (for when to start scanning) according to the batch
separation capabilities provided by the application program.
With the [Standard Feeding] Feeding Option