Intex 12 FT X 30 IN METAL FRAME POOL 2013 - Manual (Page 12)

(87PO) ROUND METAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2012
87PO
SAVE THESE INSTRUCTIONS
Page 12
English
SETUP
INSTRUCTIONS
POOL SETUP (continued)
• Next slide the vertical legs into the belt loop
located in the middle of the pool liner. The bottom of
the leg should be inside the white restraining rope (9)
(optional) located near the liner’s bottom edge.
Exceptions are the 10’ (305cm) and 12’ (366cm) size
pools. Carefully slide the leg into the belt loop and
place the leg’s bottom inside the rope and then insert
the top of the leg into the bottom of the joint. Snap this
leg into joint’s holes by aligning the holes and the
spring-loaded pin. Attach the leg’s end cap (5) to the
bottom of the leg (see drawings 3.1 & 3.2).
• Upon connecting the last leg, grab hold of the frame
pool’s top beams in 2 – 3 locations. Shake the pool to
be sure that all the joints, legs and beams fit into each
other. Ensure that all pins are in position by pushing
them downwards through the holes (see drawing 4.1).
• Pull gently, in an outward direction, the bottom of each
leg; making sure the leg is inside the restraining rope. The leg is to end up in an upright
vertical position.
3. Filling of the pool
• The following applies to pool liners with hose connectors (16’ (488 cm) & below pools). If
the pool was purchased without a filter pump, insert two of the three plugs (11) into the
black filter pump outlets. Do this from the inside of the pool so that water will not run out
when filling it.
If the pool was purchased with a filter pump, read the Krystal Clear™ Filter Pump
Manual first and then proceed to next installation step.
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and
that the drain cap on the outside is screwed on tightly. Fill the pool with no more than 1
inch (2.5 cm) of water. Check to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material bulging and a potential collapse of the pool. If the pool is not
completely level, you must drain the pool, level the area or move the pool to a
different area that is level, and re-fill the pool, following the above directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool
floor and pool sides meet. Or, (from outside pool) reach under the side of the pool,
grasp the pool floor and pull in an outward direction. If the ground cloth is causing the
wrinkles, have 2 adults pull from opposite sides to remove all wrinkles. Use the properly
assembled pool ladder when entering or exiting the pool during this process.
• Fill the pool with water up to just below the
sleeve line. (see drawing 4.2).
4. Posting aquatic safety signs
Select a highly visible area near the pool to
post the Danger No Diving or Jumping sign
included later in this manual.
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that include, at
a minimum, the important safety rules and general aquatic safety information in this manual. Review
these rules on a regular basis and with all users of the pool, including guests.
4.2
FILL LINE
3.1
8
9
5
3
3.2
4
4.1