Intex 12 FT X 30 IN METAL FRAME POOL 2013 - Manual (Page 14)

(87PO) ROUND METAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2012
87PO
SAVE THESE INSTRUCTIONS
Page 14
English
STORAGE
POOL MAINTENANCE & DRAINAGE
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp., Intex Development Co. Ltd., their related companies, authorized agents and service
centers, retailers or employees liable to the buyer or any other party for costs associated
with the loss of pool water, chemicals or water damage. Keep spare filter cartridges on
hand. Replace cartridges every two weeks. We recommend that a Krystal Clear™
Intex Filter Pump be used with all of our above-ground-pools. To purchase an Intex
Filter Pump or other accessories see your local retailer, visit our website or call
the Intex Consumer Services Department listed in the separate “Authorized Service
Centers” sheet and have your Visa or Mastercard ready.
CAUTION ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector (12).
5. Place the other end of the hose in an area where the water can be safely drained away from the
house and other nearby structures.
6. Attach the drain connector to the drain valve. NOTE: The drain connector will push the drain
plug open inside the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain,
leading any remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse set up instructions to disassemble the pool, and remove all connecting parts.
12. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the
sun for an hour before folding (see drawing 5). Sprinkle some talcum powder to prevent the vinyl
from sticking together and to absorb any residual moisture.
13. Create a square shape. Starting at one side, fold one-sixth of liner in on itself twice. Do the same on
the opposite side (see drawing 6.1 & 6.2).
14. Once you have created two opposing folded sides, simply fold one over the other like closing a book
(see drawing 7.1 & 7.2).
15. Fold the two long ends to the middle (see drawing 8).
16. Fold one over the other like closing a book and finally compact the liner (see drawing 9).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees Fahrenheit
(0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius), storage location.
18. The original packing can be used for storage.
7.1
5 6.1 6.2
7.2 8 9