Intex 18 FT 8 IN X 53 IN SEQUOIA SPIRIT POOL 2012 - Manual (Page 22)

120
PO
SAVE THESE INSTRUCTIONS
Page 22
(120PO) SEQUOIA SPIRIT ® WOOD-GRAIN FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 10/06/2011
English
SS
TT
OO
RR
AA
GG
EE
POOL MAINTENANCE & DRAINAGE
Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations may
occur. Concentrated chlorine solutions may damage the pool liner. In NO event shall Intex
Recreation Corp., Intex Development Co. Ltd., their related companies, authorized agents
and service centers, retailers or employees be liable to the buyer or any other party for the
costs associated with the loss of pool water, chemicals or water damage. Keep spare filter
cartridges on hand. Replace cartridges every two weeks. We recommend that a
Krystal Clear™ Intex Filter Pump be used with all of our above-ground-pools. To
purchase an Intex Filter Pump or other accessories see your local retailer, visit our
website or call the Intex Consumer Services Department at the number below and
have your Visa or Mastercard ready.
www.intexcorp.com
1-800-234-6839
Consumer Service 8:30 am to 5:00 pm PT (Mon.-Fri.)
CAUTION ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector.
5. Place the other end of the hose in an area where the water can be safely drained away from the
house and other nearby structures.
6. Attach the hose adapter to the drain valve. NOTE: The adapter will push the drain plug open
inside the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain, leading any
remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse set up instructions to disassemble the enclosure and pool, and remove all connecting parts.
12. Be sure pool and all parts are completely dry before storage, let it sit under the sun for an hour
before folding (see drawing 16). Sprinkle talcum powder to prevent vinyl from sticking together and
to absorb any residual missed.
13. Create a square shape. Starting at one side, fold one-sixth of liner in on itself twice. Do the same on
the opposite side (see drawings 17.1 & 17.2).
14. Once you have created two opposing folded sides, simply fold one over the other like closing a book
(see drawings 18.1 & 18.2).
15. Fold two long ends to the middle (see drawing 19).
16. Fold one over the other like closing a book and compact the liner (see drawing 20).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees Fahrenheit
(0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius), storage location.
18. The original packing carton can be used for storage.
18.1
16 17.1 17.2
18.2 19 20