Compaq N1020V - Manual (Page 137)

Removal and Replacement Procedures
Maintenance and Service Guide 5–31
4. Remove the TM2.5 × 5.0 screw 1 that secures the display
video ground cable to the heat spreader (Figure 5-23).
5. Disconnect the display video cable 2 from the system board.
6. Remove the display video cable from the routing channels in
the heat spreader and the top cover 3.
7. Remove the TM2.5 × 5.0 screw 4 that secures the display
inverter ground cable to the heat spreader.
8. Disconnect the display inverter cable 5 from the system
board.
Figure 5-23. Removing the Display Screws and
Disconnecting the Display Cables