CatEye EC-C400R - Manual (Page 10)

10
Level Adjustment
• Turn the level adjuster on the rear leg so that the unit is placed sta-
bly.
• When the indication line on the level adjuster is at the top, the rear
leg is at the same level as the caster of the front leg.
1
22
H
OW TO ADJUST EACH PART
Adjust the seat position.
• Pull the seat slide lock pin to allow the seat to slide forward/backward sitting on the seat. When the seat reaches the
desired position, release your hand from the seat slide lock pin and then attempt to move the seat slightly.
The seat position can be adjusted while pulling up the seat lock pin. When desired seat position is obtained, release the
lock pin free and move the seat slightly and the lock pin will click into the nearest hole by spring pressure. Holes are
provided at an interval of 3 cm(1-3/16").
Caution: • When adjusting the seat position, make sure to slide the seat while the grip is being held. If the
seat is slid while the control unit is being held, the unit may be damaged.
• When the seat height is set at a lower position, do not pull the spring lock pin while seated, as the
seat may suddenly slide down backward.
• When sliding the seat, take care not to break the pulse sensor cable.
1
3
7 8
6
4
2
5
2
4
2
3
1
Level adjuster
Indication line
Pull
Slide
Lock pin
Grip