CatEye EC-C400R - Manual (Page 12)

12
C
ONNECTING THE PULSE SENSOR
This model detects and displays your pulse rate during exercise by the earlobe sensor from your earlobe. Being a sensitive elec-
tronic part, the earlobe sensor must be handled with sufficient care.
Important: When the chest-belt sensor is used, remove the earlobe sensor plug from the control unit. Signals from the chest-
belt sensor cannot be received if the earlobe sensor is connected.
Use pulse (earlobe) sensor during exercise.
• Clip the pulse sensor at the center of your right or left earlobe.
• When it is cold, massage your earlobe before use to improve blood
circulation.
• Attach the cable clip to your clothes to prevent excessive swinging of
the sensor cable.
• Ear rings or other ornaments must be removed before attaching the
sensor and during exercise.
• Try not to change the position of the pulse sensor during the exer-
cise.
• When removing the pulse sensor after exercise, be sure to remove
also the cable holder.
Connect the pulse sensor.
• Insert the plug of the cable (coming out of the left side of the main
unit) into the pulse sensor jack at the back of the control unit.
• Insert the pulse sensor plug into the jack on the side of the inner pipe
end cover.
Caution: If the plug is not pushed fully home, the pulse might
not be measured correctly.
• Attach the sensor clip to the handlebar, clipping the sensor cable in
position.
Caution: Pulling the pulse sensor with forth may result in dis-
connection. Handle the sensor carefully.
1
2
3
Pulse sensor
jack
Pulse sensor plug
Sensor clip Pulse sensor plug
Pulse sensor
jack
Handlebar
Pulse (earlobe) sensor
Cable clip
Sensor clip
Pulse (earlobe)
sensor
Cable clip
Pulse (earlobe)
sensor
Use of sensor clip.
• Always clip the pulse sensor to the sensor clip when it is not being
used. This sensor clip can also be used to adjust the slack of the
cable.
33