Clarity CLS 45i - Manual (Page 17)

Desktop Use
To use as a desk phone, remove the wall
mounting bracket:
1. Remove the handset and turn the phone
over so that the bottom is facing you.
2. Push the bracket in and down firmly until you
feel it snap out of its mounting slots  .
3. Place the base on any desired and suitable
location. The small rubber pads on the bot-
tom of the phone will help keep the phone
in place.
Wall Mounting
The wall mounting bracket is already installed
on your CLS45i for your convenience. To
attach your phone to the wall:
1. Locate a desired wall phone jack near an
AC outlet. Notice the position of the two
(upper and lower) protruding nail or screw
heads as shown in illustration

. These
heads fit into the slots on the bottom of
the mounting bracket and hold the phone
on to the wall. Plug the short phone line
cord into the wall jack as shown.
2. Hold the base unit of the phone upright
then angle it downwards. Feel for the
lower protruding nail or screw head and
insert this head into the lower hole on the
mounting bracket as shown in

.
3. Next, insert the upper phone bracket onto
the upper head. Slide the phone down until
it is firmly in place on the wall. See
 .
4. Once the phone is firmly in place on the
wall, attach the short line cord to the
phone, plug the AC adapter into the phone,
and attach the phone’s handset as shown in

.
13




Installing and Using Your CLS45i
