Classe Audio CDP-102 - Manual (Page 43)

43
4. The disc is spinning but there is no sound in one or both
channels.
Check that both interconnect cables are properly connected
between the outputs of the disc player and the inputs of your
preamplifi er.
Ensure that the preamplifi er/amplifi er units being used are
properly confi gured. (You may need to consult those units’
owner’s manuals for more information.)
5. The screen shows an error message and the Eject button does
not eject the disc (or the player shows some other anomalous
behavior).
Press the Standby button so the screen dims and the blue light
goes on.
Using the rear panel power switch, turn off the unit for at least
thirty seconds. Th en turn the power back on and press Standby
to restart the unit.
6. The IR remote control seems not to function.
Ensure that there are no obstacles between the IR remote and the
IR sensor (located to the right of the Mute button).
If the batteries are weak, replace them with fresh ones.