Canon HF M31 - Manual (Page 172)

172 Š
Additional Information
Cannot enter standby mode now
- The camcorder cannot enter standby mode if the remaining battery charge is too low. Charge
or replace the battery pack ( 0 19).
Cannot play back
- There is a problem with the memory. If this message appears often without apparent reason,
contact a Canon Service Center.
Cannot play back Cannot access the built-in memory
- There is a problem with the built-in memory. Save your recordings ( 0 123) and initialize the
built-in memory using the [Complete Initialization] option ( 0 36). If the problem persists,
contact a Canon Service Center.
Cannot play back Check the memory card
- There is a problem with the memory card. Save your recordings ( 0 123) and initialize the
memory card using the [Complete Initialization] option ( 0 36). If the problem persists, use a
different memory card.
Cannot play the movies in the built-in memory Initialize only using the camcorder
- The camcorder's built-in memory was initialized using a computer. Initialize the built-in mem-
ory with this camcorder ( 0 36).
Cannot play the movies on this memory card
- Movies cannot be played back from a 64 MB or smaller memory card. Use a recommended
memory card ( 0 32).
Cannot play the movies on this memory card Initialize only using the camcorder
- The memory card in the camcorder was initialized using a computer. Initialize the memory
card with this camcorder ( 0 36).
Cannot record
- You cannot capture video snapshot scenes from scenes recorded or edited using another
device.
- There is a problem with the memory. If this message appears often without apparent reason,
contact a Canon Service Center.
Cannot record Cannot access the built-in memory
- There is a problem with the built-in memory. Save your recordings ( 0 123) and initialize the
built-in memory using the [Complete Initialization] option ( 0 36). If the problem persists,
contact a Canon Service Center.
Cannot record Check the memory card
- There is a problem with the memory card. Save your recordings ( 0 123) and initialize the
memory card using the [Complete Initialization] option ( 0 36). If the problem persists, use a
different memory card.
Cannot record movies in the built-in memory Initialize only using the camcorder
- The camcorder's built-in memory was initialized using a computer. Initialize the built-in mem-
ory with this camcorder ( 0 36).