Casio EX-Z400 EN - Manual (Page 171)

171
Appendix
Images cannot be
transferred over a
USB connection. 1)The USB cable may not be connected securely. Check all
connections.
2)The wrong USB communication protocol is selected. Select
the correct USB communication protocol in accordance with
the type of device you are connecting (pages 121, 130).
3)If the camera is not turned on, turn it on.
4)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer’s USB port.
Language selection
screen appears
when the camera is
turned on. 1)You did not configure initial settings after purchasing the
camera or the battery may have been left with a dead battery.
Check the camera setup (pages 17, 145).
2)There may be a problem with the camera’s memory data. If
this is the case, perform the reset operation to initialize the
camera’s setup (page 148). After that, configure each setting.
If the language selection screen does not re-appear when you
turn the camera on, it means that the camera’s memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
The time and date
settings configured
the first time after
purchasing the
camera are reset to
their factory
defaults when
remove the
camera’s battery. Load the camera’s battery and reconfigure the time and date
settings (page 17). Do not remove the battery from the camera
for at least 24 hours after configuring time and date settings.
After that, the settings will not be reset if you remove the
battery.
• If the time and date are reset to their factory default settings
when you remove the battery after it has been loaded for
more than 24 hours, it could mean that the camera’s setting
memory is defective. Contact your retailer or a CASIO
authorized service center.
Display Messages
ALERT
The camera’s protection function may have activated
because camera temperature is too high. Turn off the camera
and wait until it cools down before trying to use it again.
Battery is low. Battery power is low.
Cannot correct
image!
Keystone correction of the image cannot be performed for
some reason. The image will be stored as-is, without
correction (page 60).
Cannot find the
file.
The image you specified with the slideshow “Images” setting
cannot be found. Change the “Images” setting (page 93) and
try again.
Cannot register
any more files.
You are attempting to save a user BEST SHOT scene in the
“SCENE” folder when the folder already contains 999 user
scenes (page 57).
Problem Possible Cause and Recommended Action
C