CDA RV 1001 - Manual (Page 12)

12
How to Use the Multifunction Main Oven
General Features
As its name indicates, this is an oven that presents particular features from
an operational point of view.
In fact, it is possible to insert 7 different programmes to satisfy every
cooking need.
The 7 positions, thermostatically controlled, are obtained by 4 heating
elements which are:
– Bottom element
1200 W
– Top element 1000 W
– Grill element 2000 W
– Circular element 2200 W
Note:
Upon first use, it is advisable to operate the oven for 30 minutes in the position
and for another 30
minutes at the maximum temperature (thermostat knob on position 250) in the positions and , to
eliminate possible traces of grease on the heating elements.
Clean the oven and accessories with warm water and washing-up liquid.
WARNING:
The door is hot, use the handle.
ATTENTION - MOST IMPORTANT
Pay special attention not to touch the hot heating element
inside the oven cavity.
Attention:
The oven door
becomes very hot
during operation.
Operating Principles
Heating and cooking in the MULTI-FUNCTION oven are obtained in the following ways:
a. by normal convection
The heat is produced by the upper and lower heating elements.
b. by forced convection
A fan sucks in the air contained in the oven muffle, which sends it through the circular heating element
and then sends it back through the muffle. Before the hot air is sucked back again by the fan to repeat
the described cycle, it envelops the food in the oven, provoking a complete and rapid cooking.
It is possible to cook several dishes simultaneously.
c. by semi-forced convection
The heat produced by the upper and lower heating elements is distributed throughout the oven by the
fan.
d. by radiation
The heat is radiated by the infra red grill element.
e. by radiation and ventilation
The irradiated heat from the infra red grill element is distributed throughout the oven by the fan.
f. by ventilation
The food is defrosted by using the fan only function without heat.