Clarion S100 - Manual (Page 12)

9
arming while driving
Your system can be armed while driving the vehicle. Simply press on
your remote for two seconds while the vehicle is running or while the igni-
tion is on. The siren will chirp once and then once more to indicate that
the ignition is on. The security system will not respond to any input except
the door triggers and the Starter Kill (if installed) will not be activated. The
security system will disarm automatically whenever the ignition is turned
off. The siren will chirp twice and the LED will stop flashing.
disarming
To disarm the system, press . You will hear two chirps, and the
parking lights will flash twice. If the power locks are connected to the
system, the doors will unlock. If the siren chirps either four or five times
when disarming, refer to the Diagnostics section of this guide to deter-
mine which zone caused the system to alarm.
silence alarm without disarm
This feature makes it possible to silence and reset the system while it is
triggering, without disarming the system. If the system is triggered and
the siren has been sounding for longer than six seconds, pressing
or
on the remote will stop the trigger and return the unit to
the armed state. The system will not disarm, but rather reset. This pre-
vents you from disabling the system should you wish to disarm it with-
out visually checking the vehicle. Pressing
after resetting the sys-
tem will disarm the system; pressing this button during the first six sec-
onds of the triggered sequence will disarm the security system imme-
nnoottee:: If programmed for the optional Anti-Car Jacking fea-
ture, arming with the remote will arm this feature. (See Anti-
Car Jacking section of this guide.)