Clarion S100 - Manual (Page 19)

16
table of zones
The zone number is the number of LED flashes used by the system to
identify that input. The standard input assignments are listed below,
along with spaces to write in any optional sensors or switches you have
had installed.
interpreting zone diagnostics
Warn Away responses are not reported by arming or disarming diagnos-
tics. If you receive a open zone notification when arming, or a notifica-
tion of an alarm in your absence when disarming, look at the LED. Active
or triggered zones will be indicated by a pattern of blinks by the LED.
Example
If Zone 3 was active or triggered, the LED will blink three times with a
two-second pause. Then it will blink three times again, and repeat until
the ignition is turned on.
Zone - Number Dealer-Installed
of LED Flashes Description Options
1 Instant trigger - often used
for hood/trunk pinswitches
2 Instant trigger - a heavier impact
detected by the shock sensor
3 Door switch trigger
4 Instant trigger - for optional sensors
5 Ignition trigger