Cardo G4 - Manual (Page 19)

En
gli
sh
Your 4-Way Conference Intercom Pairing is now complete and ready
to use.
NOTE: If the Pairing process is not completed within two minutes the G4s
will return to Standby mode.
Making 4-Way Intercom calls
Once you have successfully paired the four G4s as described above,
and all units are in standby mode, proceed as follows to start a 4-way
Conference Intercom call:
a. Passenger 2 should press Button “B” to initiate a call with
Passenger 4. Wait until audio is heard on both G4s and proceed
to the next step.
b. Driver 1 should press Button “A” to initiate a call with Passenger 2.
c. Driver 3 should press Button “A” to initiate a call with Passenger 4.
Now the 4-way intercom conference mode is established.
NOTE: If one of the G4s should disconnect or drop off from the 4-way call and
fails to reconnect, repeat the three steps above in that precise order.
9.11 USING THE G4 FOR INTERCOM WITH OTHER
SCALA RIDER MODELS
9.11a. TWO-WAY INTERCOM WITH SCALA RIDER Q2/Q2
pro
To use your G4 with a Q2 unit, we recommend that you also refer to
your Q2 manual.
1. If either device is turned OFF, turn it ON by pressing and holding
either the Mobile Button for the G4 unit or the CTRL Button for the
Q2 until the Blue Lights flash three times.
2. Make sure that both devices are now flashing slowly in Blue.
3. On the G4, select an available CHANNEL to pair the Q2 (CHANNEL
“A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will replace the paired
headset on that CHANNEL with the newly paired headset.
4. On the G4, press and hold the assigned CHANNEL BUTTON (“A” or
“B”) for at least six seconds until the G4’s BLUE or RED Light begins
flashing rapidly, indicating it is in Intercom Pairing mode. (See Table
in 9.10).
5. On the Q2, simultaneously press and hold the CTRL and MC
Buttons until the RED Light begins flashing rapidly, indicating it is in
Intercom Pairing mode (see Q2 manual).
6. Within a few seconds, both units will show a solid light for two
seconds, indicating that they are now paired, connected and ready
for use.
NOTES:
• If the Pairing process is not completed within two minutes the units will
return to Standby mode.
• Voice Connect Intercom can only be initiated from the G4/Q2 pro .
However, you can always initiate the Intercom manually also from a Q2
unit by pressing the button.
19 scala rider ® G4