Cardo G4 - Manual (Page 23)

En
gli
sh
IMPORTANT
MULTINATIONAL ELECTRONIC COMMERCE COMPANIES AND
ONLINE AUCTION WEBSITES ARE NOT AUTHORIZED TO SELL
CARDO PRODUCTS. ANY PURCHASES FROM SUCH SITES ARE
AT YOUR OWN RISK. TO RECEIVE WARRANTY OR CUSTOMER
SERVICE, YOU MUST SUBMIT ORIGINAL RECEIPTS FROM
AUTHORIZED CARDO DEALERS.
PRODUCTS THAT WERE IMPORTED FROM NORTH AMERICA
MUST ALSO BE SERVICED THERE.
12. NOTICES
Federal Communications Commission (FCC) / Industry Canada (IC)
Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user’s authority to operate
the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC / IC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
FCC/IC RF Radiation Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instruc-
tions for satisfying RF exposure compliance. The antenna used for this transmitter
must not transmit simultaneously with any other antenna or transmitter, except in
accordance with FCC/IC multi-transmitter product procedures.
European CE Notice
The scala rider G4 headset (the “Product”) is in conformity with the following
essential requirements of Council Directive 1999/5/EC (referred to as R&TTE
Directive): Articles 3.1a, 3.1.b and 3.2. The Product is manufactured in
accordance with Annex II of the above directive.
Declaration of Conformity (DOC)
The scala rider G4 headset is compliant with and adopts the Bluetooth®
Specification 2.1 and has successfully passed all interoperability tests that are
specified in the Bluetooth® specification. However, interoperability between the
device and other Bluetooth®-enabled products is not guaranteed.
23 scala rider ® G4