Cardo G4 - Manual (Page 20)

9.11b. TWO-WAY INTERCOM WITH EARLIER SCALA RIDER
MODELS
To use your G4 with other scala rider models such as the “Solo”,
“FM”, “TeamSet
pro
” or a “TeamSet” Driver unit make sure you have the
manual of the other scala rider headset available.
1. While the G4 is turned OFF, turn it ON by pressing and holding the
Mobile Button until the Blue Light flashes three times.
2. Turn the other scala rider ON by pressing and holding its CTRL
Button until the Red/Blue lights begin rapidly alternating.
3. For the G4, select an available CHANNEL to pair the other unit
(CHANNEL “A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will replace the paired
device on that CHANNEL with the newly paired headset.
4. On the G4, press and hold the assigned CHANNEL BUTTON (“A”
or “B”) for at least six seconds until the BLUE or RED Light begins
flashing rapidly, indicating it is in Intercom Pairing mode. (See 9.10
Intercom Channel Table for details)
5. Within a few seconds, the G4 will show a solid light for two
seconds, indicating that the two units are now paired, connected
and ready for use.
NOTES:
• If the Pairing process is not completed within two minutes the units will
return to Standby mode.
• When using an earlier scala rider model to serve as the Passenger unit
(e.g. a “Solo”, “FM”, “TeamSet
pro
” or a “TeamSet” Driver unit), Voice
Connect Intercom can only be initiated from the G4. However, you can
always initiate the Intercom manually also from the other scala rider
unit by pressing the button.
Initiate Intercom calls from scala rider G4
There are two ways to start an Intercom call with your paired headsets
while the G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an
Intercom call will be established with
both paired headsets.
The Intercom call will stay on until all
participants remain silent for 30 seconds.
CHANNEL BUTTON
CONNECT:
Single tap the chosen
Channel Button to add or
remove the unit from an
Intercom call.
Initiate Intercom calls from:
Q2
pro
: Tap the MC Button once on a Q2
pro
unit to open an intercom
call. To terminate the call, tap once.
Q2: Tap the MC Button twice on a Q2 unit to open an intercom call.
Wait 3 seconds between taps. To terminate the call, tap once.
Other scala rider models: Tap the headset CTRL Button to open/
close intercom call.
9.11c. THREE WAY INTERCOM WITH OTHER SCALA RIDER
MODELS
In terms of range, the 3-Way Intercom between your G4 and
other scala rider units achieves distances of the lowest common
denominator. For example, connecting your G4 with two Q2
pro
units
will enable intercom distances of maximum 2,300 ft / 700m.
NOTE: When connected to earlier scala rider headsets (e.g. a “Solo”, “FM”,
"TeamSet pro " or a “TeamSet” Driver unit) only Rider-to-Passenger mode is
available.
All options are in Full Duplex, meaning that all parties can speak and
hear one another simultaneously, similar to mobile or landline phone
conversations and unlike walkie-talkie communications.
20 scala rider ® G4