KERN & SOHN IFS 300K-3 - Manual (Page 39)

KFS-T-BA_IA-e-1213 39
Overview:
Menu item Available settings
F0 SEL
Enable tolerance check
1 SEL0 Tolerance check disabled
1 SEL1* Tolerance check for weighing
1 SEL2* Tolerance check for counting
F1 Co
Display conditions of the tolerance
marker
11 Co0
Tolerance marker is always displayed, even if
standstill control is not yet displayed.
11 Co 1*
Tolerance marker is only displayed in connection
with standstill control.
F2 Li
Tolerance range
12 Li 0
Tolerance marker is only displayed above zero
range.
12 Li 1*
Tolerance marker is displayed for the whole
range.
F3 Pn
Number of limiting points
13 Pn 0 1- Limiting point (OK/ -)
13 Pn 1* 2- Limiting points (+/OK/-)
F4 bU
Audio signal
14 bu0* Audio sound during tolerance check disabled
14 bu1 Audio sound when load is within tolerance limits
14 bu2 Audio sound when load is beyond tolerance limits
F5 Ao
Automatic zero point correction
(zero tracking)
2 Ao0 Automatic zero tracking off
2 Ao1 Automatic limiting point correction on, 0.5 d
2 Ao2* Automatic limiting point correction on, 1 d
2 Ao3 Automatic limiting point correction on, 2 d
2 Ao4 Automatic limiting point correction on, 4 d
F6 AP
Automatic shutdown for battery
operation
3 Ap0* AUTO OFF function disabled
3 Ap1
Instrument will be switched off after 3 minutes of
inactivity of display unit or weighing bridge.
F7 UA
RS-232 mode
4 UA0 Output via RS232C interface disabled
4 UA1* Continuous data output
4 UA2 Continuous data output of stable weighing values
4 UA3
One output for stable weighing value. No output
for stable weighing values. Renewed output after
stabilization.
4 UA4
Remote control commands, see chap. 9.2.8 /
output after pressng the PRINT button
4 UA5
Standard printer setting, output after pressing the
PRINT button
4 UA6 Not documented
F8 bl.
Baud rate
41 bl 0 1200 bps
41 bl1 2400 bps
41 bl 2 4800 bps
41 bl 3 *
9600 bps