KERN & SOHN HFC 10T-3 - Manual (Page 40)

How to carry out adjustment:

Confirm adjustment function “Commo“ by .

“ULoAd“ will be displayed. Make sure that no loads
apart from the lifting tackle are attached to the hook.

Wait for stability display, then press .
Either use the displayed adjustment weight or change
by and , the currently enabled digit is
flashing.
To change the selected (flashing) digit, press
repeatedly until the desired value is displayed. Then
select further digits by and amend them by
.
(example)

Confirm by , „LoAd“ will be shown.

Attach adjustment weight. Wait for stability display,
then press .

After successful adjustment „Pass“ will be displayed.
Afterwards the balance will carry out a self-test.
“Err19“ will appear briefly (Ignore error message), then
the balance will change automatically into weighing
mode and the total weight will be displayed.
Adjustment has now been completed successfully.
(example)

In case of an adjustment error or incorrect adjustment value the error message
“fail“ will be displayed and you must repeat the adjustment procedure.
40 HFC-BA-e-1511