KGUARD Security SHA24 - Manual (Page 41)

ENGLISH
Chapter 4: Using the DVR
DVR User’s Manual
41
HDD Loss Select to enable HDD loss alarm. When the hard disk drive is not detected due to HDD
damage or the power supply malfunctions, or HDD auto-overwrite is off, the alarm will
be triggered.
HDD Space Select to enable HDD space alarm. When the hard disk drive is full, the alarm will be
triggered.
Video Loss Select to enable Video loss alarm. When DVR cannot receive the video input signal due
to camera damage, cable damage, or the power supply malfunctions, the alarm will be
triggered.
Alarm Time Select the alarm duration (30S/1 Min/2 Min/5 Min).
Pre-record
time
Enable/Disable pre-recording before the alarm occurs.
5
After all settings are complete, click Apply.
6
When data saving is complete, click OK.
Note:
To ensure that motion detection alarm is properly working, you need to enable the motion detection function. See
“4.4.5 Setting Motion Detection” on page 43 .
Email Alarm Notifications
To set up an email for alarm notifications, do the following:
1
In preview mode, right-click on the mouse to display the Pop-up menu.
Be sure that the DVR network connection is properly configured before proceeding with the email setup.
2
Select Main Menu > DEVICE > ALARM.
3
Check the E-mail check box and click E-mail Setup.
4
On SSL, check Enable check box if your email server needs the SSL verification. Check with your email service
provider for the applicable setting.
5
Enter the SMTP port and SMTP Server of the sending email server, the email address and password of the sender in
Sender and Sender PWD respectively.
Note:
By default, the SMTP port is 25 for email without SSL verification. For Gmail server or for email that needs SSL
verification, the SMTP port is 465, by default. Check with your ISP for the correct setting.
6
In Receiver, enter the email address where the email alarm is to be sent. In Interval, select an email sending interval.