KGUARD Security OT801 - Manual (Page 12)

ENGLISH
Chapter 2: Installation
12
DVR User’s Manual
Chapter 2: Installation
2.1 Installing the Hard Disk Drive
Depending on the package you have purchased, the hard disk drive may be included in the full package. If it is not
pre-installed, follow the installation instructions on this user manual.
DO NOT install or remove hard disk drive while the device power is turned on.
The 4-channel / 8-channel DVR supports one 3.5” SATA hard disk drive. To install the HDD, follow the steps below.
Note:
The illustrations below show an 8-channel DVR, same procedures apply to a 4-channel DVR.
1
Loosen the screws on the left, right, and rear sides as
shown.
2
Push back then lift up the cover to remove it.
3
Connect the data and power cables to the hard disk
drive (HDD) and the DVR.
4
Attach the HDD to the bracket using 4 screws.
5
Attach the cover and screws back in place.