LABEC Z-ZHWY-1112B - Manual (Page 3)

Laboratory Equipment Pty Ltd. 2 LEVEL INCUBATOR SHAKER 2013 VER1.01
Thank you very much for choosing ZHWY-2102/2112 series Two Layers Incubator
Shakers. To ensure a smooth operation of this unit, we would like to ask you to read
this instruction manual thoroughly, and always operate the machine as guided by this
manual. Also keep this manual with the unit for maintenance reference. In case you
meet problems with this unit, please feel free to contact Laboratory Equipment Pty
Ltd. We will help you identify the problem and provide trouble-shooting service for
you.
1. Safety Instructions
1. The unit must be properly wired to ensure safety either to the operator or facilities. It is
recommended to use dedicated line to avoid interference from other equipment.
2. Please verify the local electric power supply is in accordance with the electrical requirement
240V 50/60Hz of the unit.
3. Do not use extra power cords or lines for this unit, do not bend, entangle or twist the power
cord, or apply excessive tension to it, otherwise it may cause damage to the unit or result in
electrical shock or fire.
4. Do not touch the unit with wet hands or insert other items into the wind inlet when the unit is
running. It may cause a fire or electrical shock.
5. Do not move the unit when it is operating.
6. In case moving the unit is necessary, please be sure the unit is kept upright. Otherwise, it may
cause damage to the refrigeration system inside.
7. It is good practice to ensure that the shaking platform comes to a complete standstill before
open the door of the chamber.
8. When opening or closing the chamber door, please handle with care, do not use too much
force.
9. In case fuse has to be replaced, the electric power supply has to be cut off.
10. The unit must be placed on solid, flat floors near a grounded electrical outlet, allow sufficient
clearance on all sides of the unit, at least 20cm, for proper ventilation. Avoid locations under
direct sunlight or near heat producing equipments such as an oven.
11. After continuous refrigeration for 10 days, it is good practice to de-damp the unit by turning
on the heating function.
12. Regular check to the flask clamps is necessary to ensure they are in good status.
13. Frequent opening of the chamber door is not recommended as this may affect the temperature
recovery.
14. The unit must be kept away from volatile, flammable, explosive liquids or gases. This may
cause damages either to the unit or property losses includes facilities and buildings.
15. In case of malfunction or burning smell, the unit must be immediately ceased for checking.
16. If a thunderstorm approaches in the distance, immediately turn off the power. Lightning from
the storm may cause fire or electrical shock.
17. The above safety instructions must be followed during the operation of the unit. All persons
operating this unit should review this manual. No compensation or claim can be made against
the manufacturer if damage is caused to the personnel or facilities that result from the
improper use of this unit.