LABEC J-WD - Manual (Page 5)

Safety Precautions
The following safety precautions must be observed and followed to avoid fire hazard,
electrical shock, accidents, and other failures. Keep them in mind and make sure that all the
precautions are observed and followed properly. Laboratory Equipment Pty Limited assumes
no liability or any responsibility for any damages, accidents, or problems resulting from
negligence of the precautions.
Users
This product must be used only by qualified personnel, who understand the contents of this
operation manual. If it is handled by unqualified personnel, personal injury may result.
Be sure to handle it under supervision of qualified personnel.
Purpose of use
If the product is to be used for purposes not described in this manual, contact your
LABORATORY EQUIPMENT PTY LIMITED agent in advance.
Input Power
Use the product with the specified input power voltage. For applying power, use the AC
power cable provided. The shape of the plug differs according to the power voltage and
areas. Use the cable which is suitable for the line voltage used.
Cover
There are parts inside the product which may cause physical hazards. Do not remove the
external cover. If the cover must be removed, contact your LABORATORY EQUIPMENT
PTY LIMITED agent in advance.
Installation
When installing products be sure to observe Installation Precaution described in this manual.
To avoid electrical shock, connect the protective ground terminal to electrical ground (safety
ground).
When applying power to the products from a switchboard, be sure work is performed by a
qualified and licensed electrician or is conducted under the direction of such a person. Be
sure to use the AC power cable provided.
Relocation
Turn off the power switch and then disconnect all cables when relocating the product. Use
two or more persons when relocating the product which weights more than 20 kg. The
weight of the products can be found on the rear panel of the product and/or in this operation
manual. Use extra precautions such as using more people when relocating into or out of
present locations including inclines or steps. Also handle carefully when relocating tall
products as they can fall over easily. Be sure the operation manual be included when the
product is relocate