LABEC J-WD - Manual (Page 9)

4.2 How to operate
• Check rated voltage of the apparatus as well as check the specification
• Close ‘3’ drain valve.
• Connect cooling water supply hose to “2” and supply cooling water.
• Make sure water is running from “4”.
• Water starts running from “4” only after the inner tank is filled with water.
• Control the water pressure adequately so that water flows little from “7”.
• If water flow is big, then it might result in overflow of water leveller.
• Connect the power cord to the power outlet.
• Do not plug in the power plug when water is not running from “4” and it may lead to physical
heater damage.
• Confirm that ‘6’ lamp is turned on.
• After 10 minutes, water starts to boil and distilled water runs from ‘1’ Distilled Water Outlet.
When you use this device for the first time, the distilled water is not pure, so let it run for
1hour, then collect the water that comes after 1 hour
• If the temperature of installation location goes below freezing point of water, disconnect the
hose connected ‘2’ Cooling Water Inlet Port, discharge all the water inside the by opening
‘3’drain valve after operation is done.
5. Maintenance and service.
5.1 In case of cleaning the apparatus.
Ensure that the apparatus has cooled down to a safe temperature to touch.
- Remove power plug from power outlet.
- Ensure that the apparatus has cooled down to a safe temperature to touch.
- Clean the inside part of the tank carefully and remove residues.
- Clean the casing with sponge or soft clothes getting wet by water.
- Clean with dry clothes.
- Do not use organic solvent.
- Do not use flammable or volatile chemicals such as benzene alcohol to clean.
Do not use flammable or volatile chemicals such as benzene alcohol to clean the equipment.
This equipment is not designed nor manufactured Explosion-proof, so never place highly
flammable
material or explosive material inside the apparatus which may cause an explosion or a fire.
5.2 When the equipment is not used for long time.
- Remove power plug from power outlet.
- Clean with soft clothes.
- Pack the equipment in an appropriate way and store in a safe place for storage.