Channel Plus MDS-6 - Manual (Page 18)

Page 10
1) Remove the Decora cover plate, and controller face plate.
2) Place your wireless remote in learn mode.
3) Select the device bank button to program (i.e. TV, VCR, Tuner, Aux, etc.) on the wireless remote.
4) Select the button to be programmed on the learning remote. (i.e. 1-6, mute, or volume up and down)
5) While holding the wireless remote within 2" from the top, center, clear LED on the MCS-1 (this is the
controller IR emitter), press the command button on the MCS-1 Controller you wish to program into the
wireless remote.
6) The wireless remote should then accept the MCS-1 command.
7) Once you have programmed the source number, volume up and down, and mute functions. You
can then go to the memory bank on your wireless remote chosen for the MDS-6 system to change
volume, source, or mute the system from any zone in the house.
*Please Note:
When programming, it is best to hold the MCS-1 or MCS-2 button until the wireless remote has indicated
that it has learned the command.
PROGRAMMING A WIRELESS REMOTE
USING THE MCS-1 OR MCS-2 WALL CONTROLLER