Malone MPG460XT User Manual
Page 5
800-295-0042 ext 206
5
MPG460XT
2. Attach the spring hanger brackets to the frame. The U
shaped shackle bolt brackets mount to the front and the
C shaped “slipper” brackets mount to the rear as shown.
Use 3/8” x 1” bolts and nuts. Assemble with the nuts on
the inside of the
frame rails. Fully
tighten all 8 bolts
now.
3. Lay the two frame cross mem-
bers in between the frame rails. The
two holes in the middle should face
DOWN as shown. Channels face
each other.
4. Bolt the frame rails to the cross members
using 3/8” x 1” carriage bolts and nuts, (no
washers). The square carriage heads go to
the outside with the square holes in the frame
rails. Leave the nuts loose until after all bolts
are installed. Then we will tighten everything
at once in a later step.