MF Digital DIRECTOR CD/DVD Combo Series (Rev: 08/01/02) - Manual (Page 31)

DIRECTOR Series Operator’s Guide Document Revision: 0802
Page 30
•
Click the Perform Test button. The screen will now display:
•
Place a blank disc on the input spindle.
•
Click the Yes button.
•
The disc will be loaded from the input spindle and remain suspended over
reject centering spike, awaiting printer drawer to be opened:
•
Open the printer tray by pressing the button on the front panel of the
printer.
•
Click the Yes button.
•
The disc will be loaded onto the printer tray. Observe the disc’s position
on the tray. The CD fits into the inset on the printer tray.
•
The screen will now display:
•
Click the OK button. The disc will be unloaded onto the output spindle. If
the printer alignment is correct, press the printer retaining guides snugly
against the base of the printer and tighten down their screws. If the
alignment is not correct, adjust the position of the printer as needed and
repeat the procedure.
•
When aligning the printer is completed click the Exit button. The screen
will now display: