Microtel DialStat (With Fault Indicators) - Manual (Page 17)

MICROTEL DialStat
TM
15
z Answer Delay The number of rings the dialer will see before answering an incoming
call.
*02 Review
answer delay
**02nn Program answer delay
Example- Command:
**0205
Response: The answer delay is zero five.
z Access Code This 2 digit access code is required to access configuration commands
during a telephone call to or from the dialer.
*03 Review value of access code
**03nn Program access code
NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable
access code requirement. Access code is not required to configure the dialer through
the local PHONE jack.
Example- Command:
**0313
Response: The access code is one three.
z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-
arm an acknowledged alarm and begin calling again as a reminder that the alarm
condition still exists.
*04
Review snooze delay time interval
**04HH Program snooze delay time interval
Example- Command:
**0412
Response: The snooze delay is one two.
z Firmware Version
*05 Report
Firmware Version
Response will play back all resident vocabulary, then Speak “Number 14”, where 14 is
the current Firmware version.