Muse Research Musebox manual v1.0 - Manual (Page 34)

34
Here are the parameters for the effects you can control in the MIX section:
Effects 1 Tag: Select the effects preset category of Effect 1.
Effects 1 Preset: Select the Preset within the current Tag for Effect 1.
Effects 1 DRY/WET amount: Adjust overall Effect 1 amount.
Effects 1 Mode (either INSERT, or SEND): Change signal path of Effect 1.
Effects 2 Tag: Select the effects preset category of Effect 2.
Effects 2 Preset: Select the Preset within the current Tag for Effect 2.
Effects 2 DRY/WET amount: Adjust over all Effect 2 amount.
Effects 2 Mode (either INSERT, or SEND): Change signal path of Effect 2.
Passive Mix C+D: Mixes inputs C and D (unprocessed) with the main outputs.
MIX also allows you to adjust the levels and panning of any of the individual channels inside
MuseBox . For example, to adjust the volume of the SYNTH 1 channel, simply press MIX and then
SNTH 1:
When you select SNTH 1, SNTH 2, AUD 1 or AUD 2, the MIX menu allows you to do the following:
Adjust Volume for Synth 1 / Synth2 / Audio 1 / Audio 2
Adjust Panning for Synth 1 / Synth2 / Audio 1 / Audio 2
View the Output Meters for Synth 1 / Synth2 / Audio 1 / Audio 2 channels
You can configure the mixer effects as "INSERTS" (all signals go through the effects) or "SENDS"
where the amount of the effect is variable by channel. If you have configured a mixer effect as a
"SEND" effect, then you can adjust the amount of that effect by pressing the MIX button and the
channel you are interested in. Just after you see the output meters, you will see the following
parameters beome available:
FX1 Send amount for the selected channel (ONLY IF Send FX 1 is enabled).
FX2 Send amount for the selected channel (ONLY IF Send FX 2 is enabled).
If there are no MIX effects configured as "SEND" effects, then the SEND menu for that effect will
say: (Not Available).