Control elements and terminals, Mc-1.2 front panel, Mc-1.2 rear panel – MUTEC MC-1.2 User Manual
Page 10
10
Control Elements and Terminals
MC-1.2 Front Panel
4
3
2
5
1
6
7
1 »POWER«
This red LED lights up when the unit is switched on with the rear panel power switch.
2 »MENU«
Use this key to access the different menus.
3 »SELECT«
Use this key to select a function within a specific menu.
4 »AUDIO
IN
«
This menu allows to select the one of the four, respectively five digital audio inputs/formats for converting into an USB audio
stream to send it to your computer or laptop.
5 »STATUS
SYSTEM
«
This menu indicates various signal lock conditions of the incoming reference signals and the power supply status of the whole
device.
6 »STATUS
AUDIO INPUT
«
This menu informs about the status bit settings within a received digital audio signal.
7 »CLOCK
IN
«
This menu indicates the clock rates of the incoming USB audio stream (»U«) and the the digital audio signal (»A«).
4
3
2
5
1
6
7
8
1 »S/P-DIF OUT«
These two S/P-DIF outputs, available as optical and coaxial interfaces, transmit an optical (»OP«) and unbalanced electrical
(»CO«) S/P-DIF digital audio or blank frame signal in compliance with the IEC 60958 standard. The coaxial interface impedance
is 75 Ω. (RCA connector), the optical interface offers a Toshiba Toslink
TM
connector, EIAJ standard.
MC-1.2 Rear Panel