NORAC UC4.5-BC-JD8A - Manual (Page 22)

20
6. Install the linear sensor mounting bolt in the hole of the upper bracket that closest aligns
the end of the sleeve with the center of travel mark (black mark) on the sensor (Figure
20). If the mark is missing, the distance from the end of the sleeve to the top of the base
should be 4” (100mm). The collar (Figure 19) clamps the sensor and prevents the rubber
grommet from sitting on the bolt threads. Tighten the mounting hardware.
Figure 20: Center Mark Location
Centerline
Mark
4”
(100mm)