NORAC UC4.5-BC-JD8A User Manual
Page 32
Advertising
30
10. In several cases, the lower cylinder mount on the roll control hydraulic cylinder has failed.
In the documented cases, the bracket has failed at the weld shown in Figure 35. It is
recommended that all sprayers with roll control add weld to the existing bracket to prevent
failure. Some sprayers from 2005 and newer already have gussets added at the factory.
Figure 35: Roll Cylinder Mount Weld Locations
11. Install the 6MB-6MOR (F12) fittings into the cylinder.
12. Install the 4MOR-4FORX90 (F14) fitting onto the cylinder fitting at the cap end of the
cylinder.
Figure 36: Roll Cylinder Installed with Hoses
Advertising