Hardware installation – Novak ESC Profile Software User Manual
Page 11
NOVAK ELECTRONICS • PROFILE SOFTWARE
11
HARDWARE INSTALLATION
1. Install 9V Battery
–Remove the four (4) screws from bottom of DataLink case
with a number 1 phillips screwdriver.
–Connect a 9 volt battery (Not included) to the battery harness.
–Position battery in battery box and replace bottom of case.
–Replace the four (4) screws, being careful not to overtighten.
2. Connect the DB9 end of the included DB9/RJ11 adaptor to the
communications serial port (#1 or #2) of your computer.
3. Connect the included RJ11 cable between the RJ11 side of the
DB9/RJ11 adaptor and the RJ11 port on the side of DataLink case.
Note: Any RJ11 (6-
conductor) cable
may be used if the
included cable gets
damaged or if a
longer or shorter
cable is desired.
Figure 10:
Photo showing hook-up
of DataLink hardware.
RJ11 Cable
D•LINK harness
Cyclone