Novak ESC Profile Software - Manual (Page 13)

NOVAK ELECTRONICS • PROFILE SOFTWARE 13
INSTALLING/RUNNING SOFTWARE
This procedure will copy all of the files from the included diskette
onto the hard drive in a sub-directory titled “Novak”:
WINDOWS 3.1 ® & WINDOWS 95 ®
1. Insert the included diskette into the 3.5” floppy disk drive.
2. Click on the “Start” icon, and select the “RUN” option.
(Select “File” option then “Run” option for Windows 3.1 ® )
3. At the indicated computer prompt, enter the given response:
If you are using drive B then “B:” will be displayed.
Computer Prompt Enter the Following
Open: A:SETUP {click OK}
Note: There is no space between “A:” and “SETUP”.
(“Command:” is computer prompt shown for Windows 3.1
® )
4. To run the Profile Software program, execute the program file
“SPDCTRL.EXE” by clicking on “RUN1” or “RUN2”, depending
on which serial port you connected the DataLink to.
MS ® DOS
1. Insert the included diskette into the 3.5” floppy disk drive.
2. At the indicated computer prompts, enter the given responses:
Computer prompts are shown for drive A, if you are using drive B then “B:” will
be displayed. The “INSTALL A: C:” statement instructs the computer to install
the files onto hard drive C, if you wish to use a different hard drive location then
you will type the command with the desired drive, such as “INSTALL A: D:”, etc.
Computer Prompt Enter the Following
A: {press Enter}
A:\ INSTALL A: C: {press Enter}
Note: There is a space between “INSTALL” and “A:”, and before “C:”.
3. To run the Profile Software program, execute the SPDCTRL.EXE
program by entering the given response:
The “RUN1” statement instructs the computer to use serial port #1, if you con-
nected the DataLink to serial port #2 then you will type “RUN2”.
Computer Prompt Enter the Following
C:\Novak RUN1 {press Enter}
This will execute the SPDCTRL.EXE program and you are ready to
use the Profile Software to upload, download, customize, and store
Profiles for your Cyclone Programmable speed control.