Novak ESC Profile Software - Manual (Page 16)

NOVAK ELECTRONICS • PROFILE SOFTWARE 16
EDITING PARAMETERS
This function of the Profile Software is where you will be able to
edit and customize Profile 4 of the Cyclone and it’s parameters.
You are able to work in the Edit Current Parameters mode at any
time, you do not need to have the speed control connected to
the DataLink.
1. From the main menu, use the up {
↑
} or down {
↓
} arrow keys
to highlight “Edit Current Parameters”, then press {Enter} to
select. Edit Current Parameters refers to the version of Profile 4
that is currently active in the Profile Software.
2. Use the up {
↑
} or down {
↓
} arrow keys to highlight the
available parameters, then press {Enter} to modify the value.
3. For Deadband, Drag Brake Value, and Minimum Drive the
values are entered as percentages measured to the nearest tenth
of one percent (0.1%), and the decimal place is fixed and does
not need to be entered. So values will be entered as 100 for
10.0%, 101 for 10.1%, 102 for 10.2%, etc.
Note: To enter values less than 10.0% you will need to include the
leading zero (051 for 5.1%, 052 for 5.2%, 099 for 9.9%, etc.) or
move the cursor one position to the right, using the right {
→
} arrow
key, before entering the value.
4. To modify Drive PWM Frequency, Brake PWM Frequency,
Drag Brake Frequency, or Drag Brake Toggle use the up {
↑
}
or down {
↓
} arrow keys to highlight one of these four param-
eters. The pop-up list shows the available choices.
•To change the frequency, hold down the Control {Ctrl} key
and use the up {
↑
} or down {
↓
} arrow keys to highlight the
desired frequency, then press {Enter} or {Return} to select it.
Note: If you do not press {Enter} or {Return}, the program will
revert to the previously entered frequency.