Canon H12157 - Manual (Page 314)

15-10 The Menu System Chapter 15
RX SETTINGS
1.ECM RX Turn the ECM (error correction mode) receiving off and on. This switch does
not affect the button setups for One-Touch or Coded Speed Dialing.
ON All receptions are conducted with ECM if the other party’s fax supports
ECM.
OFF ECM is turned off.
2.RX MODE Set the receive mode.
FAX/TEL AUTO SW This mode is economical, it allows you to have phone and fax service
without the expense of an additional phone line.
RING START TIME Set the duration that the LASER CLASS 2060P listens for a fax tone before
starting to ring.
8 SEC (0 to 30)
F/T RING TIME Set the length of time the LASER CLASS 2060P will ring to alert you of an
incoming call.
15 SEC (10 to 45)
F/T SWITCH ACTION Select the action taken after the F/T RING TIME expires.
RECEIVE The fax will switch to fax receive mode automatically at that point and start to
receive the document.
DISCONNECT The fax disconnects the call.
FAX ONLY MODE Use this mode if the LASER CLASS 2060P will be connected to a separate
telephone line used only for transmitting faxes. The LASER CLASS 2060P
then answers all calls, and receives all faxes automatically.
DRPD Some phone companies offer a distinctive ring pattern (DRP) service
whereby they assign two or more telephone numbers with distinctive ring
patterns to a single telephone line.
NORMAL RING Ring type of normal telephone line.
DOUBLE RING Two short rings at regular intervals.
SHORT-SHORT-LONG Short-short-long at regular intervals.
SHORT-LONG-SHORT Short-long-short at regular intervals.
OTHER RING TYPE Patterns other than those described above.
Above settings: UNIT TELEPHONE #
UNIT NAME
RX MODE TEL, FAX, FAX/TEL AUTO SW
FAX/TEL AUTO SW RING START TIME 8 SEC (0 to 30)
F/T RING TIME 15 SEC (10 to 45)
F/T SWITCH ACTION RECEIVE/DISCONNECT
(Default settings are shown in bold type)