Creda 41202 - Manual (Page 22)

Installation Instructions
22
Unpack the components from inside the grill and oven: Check that
the following parts are present.
Grill pan and grid Grill pan handle
Baking dish Pan supports (2)
Oven shelves (2) Enamelled discs (4)
Literature Brass burner port rings (4)
Battery 1.5V Aluminium burner bodies (4)
The cooker must be fitted with a stability device firmly secured to
the fabric of the building. Ventilation slots at the rear of the cooker
can be used to engage a stability bracket. Keep the bracket clear
of controls and pipes on the rear of the cooker.
The bracket must be
fitted to the wall behind the
cooker. The diagram is a
guide to the correct height
at which the bracket should
be from the floor to engage
a slot at the rear of the
cooker.
The cooker is designed to match the depth of standard 600mm
worktops. An adaptor backplate should, therefore, be fitted within
the shaded area shown to allow the cooker to be pushed fully to
the wall. If a forward facing backplate is used, it must be chased
into the wall.
Connection to the cooker should be made with an approved
appliance flexible connection to BS 669. Hoses connected to the
L.P.G. models should be suitable for L.P.G. and capable of with-
standing 50 mbar pressure A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that
when the cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are
likely to come in contact with the flexible hose do not exceed
70
o C.
Unpacking the
Cooker
Stability Bracket
Connecting To
The Gas Supply
62 - 68mm
Floor to bracket.
200
250
250
550
680