Creda 41202 - Manual (Page 23)

23
Installation Instructions
After installation, check for gas soundness. The supply pressure
can be checked at the grill injector. Access to the injector is by
first removing the baffle at the front of the grill fastened by two
screws. Then remove the fastening screw on the right hand side
of the burner and slide the burner off the injector. Ensure that the
grill burner is correctly located under the fixing screw on
reassembly.
Fit the battery. Fit the hotplate burner bodies, burner port rings,
enamelled discs and pan supports referring to the instructions for
use where necessary.
1. Check that the hotplate and grill burners ignite correctly and
burn with a steady flame. Check for a steady flame on the low
setting.
2. Check that with the oven set to mark 9, the burner ignites at
low rate, and then increases to full rate within 60 seconds.
Leave the oven full on with the door closed for 10 minutes, and
check that when the control is turned to the ‘E’ setting that the
flame reduces.
Instruct the user on the operation of the cooker.
Operational
Checks