Country Flame Bayvue DV 30 - Manual (Page 36)

5.
Clean the doorframe as necessary to prepare for new glass. All old glass tape, broken glass, and debris
should be removed from the frame in order for the new glass and glass tape to fit properly in place.
6. Position and install the three glass panels, FIGURE 22, left view, Item D and Item F in the doorframe.
The third glass panel is not shown in FIGURE 22. All glass comes pre-taped with fiberglass
insulation, FIGURE 22, left view, Item B.
7. Set glass retainers, FIGURE 22, right view, Item H in place over the glass. Reinstall twenty #6 nuts
and four #10/32 screws, FIGURE 22, right view, Item J onto Item I to hold retainers in place. DO
NOT over tighten.
8. Install door rope gasket, FIGURE 22, left view, Item F, using small amount of rope cement to hold
rope gasket in place.
9. Reinstall assembly, FIGURE 24 to stove body. Close door latches, securing assembly to Bayvue DV.
10. The door assembly is a sealed unit. Refer to door seal section. Reread test procedures and check door
seal. Perform test seal procedure to ensure door assembly fits properly to Bayvue DV body. Contact a
local authorized Country Flame Dealer or a certified professional if there are any issues with the seal.
WARNING: THIS PRODUCT IS A SEALED APPLIANCE. THE DOOR ASSEMBLY
MUST SEAL AGAINST STOVE BODY FOR PROPER OPERATION. NEVER
OPERATE THE STOVE WITH BROKEN GLASS OR WITH THE DOOR OPEN. ANY
LEAKAGE MAY CAUSE DANGEROUS INDOOR AIR POLLUTION. DO NOT ABUSE
DOOR GLASS, SUCH AS SLAMMING THE DOOR OR STRIKING THE GLASS.
Version 1.0h 35
WARNING: USE COUNTRY FLAME REPLACMENT PARTS (EXACT PART NUMBERS). REPLACE
PARTS AS COMPLETE ASSEMBLY WHERE NECESSARY. REFER TO GLASS CLEANING SECTION.