Carrier Access Adit 3500 User Manual
Page 15
Adit 3500 - Release 1.6
15
Quick Start Guide
Installation
#2 Adit 3500 and Battery Backup mounted to the wall
This method requires a more wall space. Note: This installation will require a minimum of wall
space of: 17" (H) x 14" (W) x 2.5" (D).
1. Mount the Battery Backup to the wall with (4) #6 screws, by:
z
Mark the location of the left-side 2 screws (using the BBU mounting keyhole as a guide).
Note: this installation of the BBU is oriented with the mounting keyholes to the left side.
z
Screw these 2 screws into the wall at marked locations. Note: do not screw tight to the wall,
leave 1/4" to allow BBU mounting keyholes to slip over screw head.
z
Attach the BBU by slipping the screw heads through the keyhole slots at the left of the
BBU, and slide unit to the right to allow screwheads to enter the narrow end of the keyhole.
z
Screw the second set of 2 screws into mounting holes on the right of the unit.
z
Tighten all screws to the wall.
2. Insert Adit 3500 Power cord through the holder on the top of the BBU. This supports the
weight of the adapter portion of the power cord.
3. Attach Adit 3500 to the wall following the instructions, Wall Mounting on page 9.
Attaching the Adit 3500 to the wall above the BBU.
Note: there is a distance limit between the Adit and the BBU (note the length of the battery
cable to the Adit).
4. Attach power cords.
z
Connect cord from BBU to the Adit 3500 (2 pin connector).
z
Connect 12V power cord to Adit 3500.
Adit 3500
Battery Backup
Front
Back
Holds AC Adapter
portion of power
cord
Battery Cable