Cortelco FOUR LINE CORDLESS ANALOG ADAPTER 2742 User Manual
Page 11
8
3.2.
Station Name Assignment
A name may be assigned to each 4-Line telephone unit. This name will display during Intercom calls.
Name assignment must be done from Station 01 and must be done with a 2740 or 2750 telephone.
To assign a name to a station:
a.
Press MENU. The display will read “Phone Setting”
b.
Press the soft key under ENTER.
c.
Press the Down Arrow repeatedly until the display reads “Station Naming”
d.
Press the soft key under ENTER. The display will show the currently stored name for station
#01, or indicate “No Name” if no name has yet been given to station #01.
e.
Press soft Key under CHANGE if you wish to store a new name for station #01, or press
DOWN ARROW repeatedly until you see the station number that you want to name, and then
press the soft key under CHANGE.
f.
Use the dial pad numbers to enter the name for the desired station.
g.
Press the soft key under SAVE.
Repeat steps “a” through “g” for any additional stations you wish to name.
After assigning a Station Name at Station #01, it may take twenty four hours to update all
telephones.
The table below shows the dial pad numbers to press for different letters and special characters.
Note that you can press the 0, *, and # buttons if you want those characters, and you can press the
down arrow button below the display to leave an empty space. Press the DELETE button to make
corrections.
0
0
1
,
-
'
&
.
(
)
1
2
A
B
C
a
b
c
2
3
D
E
F
d
e
f
3
4
G
H
I
g
h
i
4
5
J
K
L
j
k
l
5
6
M
N
O
m
n
o
6
7
P
Q
R
S
p
q
r
s
7
8
T
U
V
t
u
v
8
9
W
X
Y
w
x
y
9
*
*
#
#