Pro Boat PRB08014 - Manual (Page 11)

ShockWave ™ 26 11
EN
Rudder Service
1. Disconnect the water tube from the rudder.
2. Remove the linkage from the rudder arm with Ball Link
Pliers.
3. Turn the rudder and loosen the set screw from the
rudder pin.
4. Turn over the boat and lightly tap the rudder to
remove the pin.
5. Assemble in reverse order.
Propeller Service
1. Use an 8mm nut driver (DYN2805) to loosen the nut
from the driveshaft.
2. Remove the nut and propeller from the driveshaft.
3. Assemble in reverse order. Correctly align the
propeller with the drive dog on the driveshaft.
Prop Angle Adjustment
NOTICE: Raise or lower the drive strut small amounts.
Raising or lowering the strut may damage the hull
around the stuffing tube.
Raising the drive strut increases speed, but also
decreases steering response and increases cavitation.
Lowering the drive strut increases steering response, but
also increases steering sensitivity and decreases speed.
1. Loosen the nuts and bolts from the drive strut on the
rear of the boat.
2. Slide the strut up or down to change the angle of the
propeller in relation to the hull.
3. Adjust as desired and tighten the nuts and bolts.
Water Cooling System
If water does not stream out of the water outlets while
the boat is moving forward, immediately stop the boat
and clean the obstruction from the water cooling system.
1. Disassemble and clean the water cooling system to
remove blockage and prevent overheating.
2. Replace damaged parts.