Pro Boat PRB08014 - Manual (Page 6)

ShockWave ™ 26 6
EN
Installing the Battery Pack
1. Loosen the 2 screws on the rear of the canopy.
2. Carefully lift the rear of the canopy and pull back to
disengage the 2 front pins from the hull.
3. Install the battery in the compartment. Secure it with
the hook and loop straps. If running your boat in
rougher water conditions, the use of Waterproof Hook
and Loop Tape (DYNK0300) may also be needed to
fully secure the battery.
4. Connect the battery pack to the ESC power
connector.
Tip: Move the packs forward or back to adjust the
center of gravity for your boat. Move the packs toward
the bow so the bow rides lower in the water. Move
the packs away from the bow so that the bow rides
higher in the water.
Antenna Tube Installation
Install the receiver antenna in the tube as shown.
Keep the end of the antenna above the boat’s
waterline to get the best transmitter reception.
Apply clear tape (DYNM0102), if desired.
NOTICE: Do not cut or kink the
receiver antenna or damage may
result.
Trim Tab Adjustment
Tip: Ensure the trim tab panels are either perpendicular
to or parallel to the bottom of the boat.
You may desire to bend the trim tabs for wind and water
conditions. To adjust the angle of the trim tabs, use a
large pair of pliers to bend the tabs. This must be done
carefully so that you do not damage the hull.