Ram Trucks 2013 Chassis Cab - User Guide - Manual (Page 18)

Tether Anchorage Points At The Right And Center Front Seat (Regular Cab - All Seats):
• Place the child restraint on the seat and adjust the tether strap so that it will reach over
the seat back under the head restraint to the tether anchor directly behind the seat.
• Lift the cover (if equipped), and attach
the hook to the square opening in the
sheet metal.
• Install the child restraint and remove
the slack in the tether strap according
to the manufacturer's instructions.
Child Restraint Installation Sequence (Mega Cab® - Rear Seats):
• Place a child restraint on each outboard rear seat and adjust the tether strap so
that it will reach under the head restraint to the tether anchor directly behind the
seat.
• Lift the cover, and attach the hook to the square opening in the sheet metal.
• Install the child restraint and remove the slack in the tether strap according to the
manufacturer's instructions.
Child Restraints Installation Sequence (Quad Cab®/Crew Cab - Rear Seats)
The top tether anchorages in this vehicle are tether strap loops located between the
rear glass and the back of the rear seat. There is a tether strap loop located behind
each seating position. Follow the steps below to attach the tether strap of the child
restraint.
Right or Left Outboard Seats:
1. Raise the head restraint and reach between the rear seat and rear glass to access
the tether strap loop.
Head Restraint In Raised Position Tether Strap Loop With Center Head Re-
straint In Raised Position
GETTING STARTED
16