Possible problems, causes and solutions – Reliable EV1 User Manual
Page 29
27
PROBLEM
Poor suction
Anomalous noise of the motor
The machine is at pressure but
it does not release steam
Extension wands or
accessories come loose easily
Extension wands or
accessories are hard to fit
The red light indicating
that the tank is running out of
water, comes on
The red light indicating
that the tank is running out of
water, comes on
POSSIBLE CAUSE
t 5IFBJSmMUFSJTEJSUZ
t 5IFSVCCFSTDSBQFSTPGUIF
cleaning brush have not
been fitted correctly
t -PXTVDUJPOQPXFSPG
the machine
t 5IFnFYJCMFIPTFJT
clogged/kinked
t 5IFXBUFSESBJOIPTF
is clogged
t 5IFMFWFMPGDMFBOXBUFSJOUIF
tank is too high (above the
white mark inside the tank)
t 5IFXBUFSJOUIFEVTU
collecting tank is at max level
t 5IFTUFBNSFHVMBUPSLOPC
is closed
t 5IFMPDLJOHMFWFSJTOPUMPDLFE
t 5IFDPOOFDUJOHHBTLFUT
produce friction
t 5IFMPDLJOHMFWFSJTOPUJOUIF
central position
t 5IFXBUFSSFTFSWFIBT
been used
t 5IFXBUFSSFTFSWFIBT
been used
SOLUTION
Clean the filter
Check they have been fitted
Operate button 10 (fig. 12)
on the handle and increase
the suction power
Disconnect the hose from the
machine and eliminate any dirt
Eliminate any impurities from
the drain hose (fig. 29)
Empty any water in excess
of to the correct level
Drain water off the dust
collecting tank
Turn regulator 41
(fig. 11) anticlockwise
Shift the lever to
position 1 (fig. 5)
Lubricate the gaskets
with some oil
Turn the lever to the
central position
Fill the tank with water and
wait some 30 minutes.
If the light does not go off,
address to the Technical
Service Centre.
Fill with water
POSSIBLE PROBLEMS, CAUSES AND SOLUTIONS
MAINTENANCE